Handle only is loose tighten the set screw on the bottom of the handle standoff with a 3 32 allen wrench.
Tighten door handle sub zero.
Remove the handle by removing the set screws from the underside of both handle standoffs.
A 3 32 allan wrench is needed to tighten the set screw on a sub zero stainless steel handle.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Remove the screws from the side mounting brackets.
If the end caps are tight to the door and the handle is loose service is needed.
Tighten the handle.
Refer to the images above.
A small amount of blue loctite may also prevent the mounting stud from loosening in the.
Designer formerly integrated series remove the molding trim from the door or drawer.
Contact factory certified service to schedule an appointment for repair.
Both l shaped and flat allan wrenches can be used.
This is usually driven with a small allen key.
This may be part of an allan wrench set or can be purchased through a local hardware store.
It is between.
Tighten the handle screws from the back side.
There should be a small set screw on the inside of the handle opposite side of the picture.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Remove the screws from the side mounting brackets.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Remove the magnetic caps covering the side mounting brackets.
Don t over tighten as they strip easily because they are so small.
The door must be partially disassembled to tighten the handle.
For allen wrench information see wrench size used to tighten a sub zero handle.
Use whatever screwdriver or wrench is appropriate to tighten this screw and firm up the doorknob s grip on the spindle.
Remove the magnetic caps covering the side mounting brackets.
Once the handle and standoffs are removed from the door tighten the standoff mounting stud with a flat head screwdriver.
The handle on a wolf range or wall oven should not be loose.
This video is about removing and re installing asub zero handle.
Loosen the screw place the handle back on flush against the door surface and tighten the screw finger tight.