If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments.
Spring adjustment garage door.
If the torsion springs do not increase in tension as the 1 4 turns are added to the springs then you probably have the torsion springs reversed.
There are two torsion springs at each side of the garage door.
Adjusting garage door springs is a common repair.
Torsion springs must be adjusted with the door in the down position.
This video applies t.
Garage door springs are used to offset the weight of the door.
When garage doors won t close all of the way or they close unevenly spring adjustment may be called for.
Once the spring is free of tension remove from its track hanger.
Troubleshooting garage door springs.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
Retest the door balance as you did in step 1.
Both the winding and stationary cones are professionally installed for safe operation.
Without the springs the door is very difficult to lift.
If adjustment of the rear track hanger is necessary the door must be locked in the closed position because the weight of the door is supported by the rear hangers.
Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.
Adjusting garage door extension.
The springs are located at the top inside part of the garage door.
All dura lift springs meet the dasma standard rating of 10 000 plus door open and close cycles.
A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.
The other is attached to a pulley connected to the cable.
The torsion spring helps the garage door open and close easily.
One end of the spring is connected to the garage door track or frame.
Adjust the springs on both sides of the door the same way.
Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension.
If it was opening too quickly move it to the next lower hole.
Garage door springs offset the weight of the door and allow it to open and close with ease.
Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage.
Adjust the spring into the proper position and make sure your garage door closes all of the way.